How to Apply

Tip: Curl your natural lashes first for a seamless blend.

1. Start with clean, oil-free lashes. The band may be applied over mascara, although it will then not be reusable.
2. Peel the band from the tray at its outer edge with the Non-Stick Lash Applicator Tweezer, taking care not to touch the adhesive.
3. Hold it beneath your natural lashes to check the fit, and trim the outer edge to match your eye shape.
4. Set the center of the band beneath the center of your natural lashes first, then secure each corner, leaving a slight gap between the band and your waterline. Keep it off the skin, where it may block the meibomian glands.
5. Clamp along the full length of the band with the tweezer to fuse the adhesive with your natural lashes. Thorough clamping locks it in place for a longer hold.
6. Re-clamp at any time to restore the hold, and avoid oil-based products, which break down the adhesive.

How to Remove

Soak a cotton pad in micellar water or makeup remover and hold it against your lashes for 15 to 20 seconds. Slide the band away from your lashes with the pad in a gentle downward motion. Brush through your lashes with a spoolie, then clear any remaining adhesive with a cotton bud soaked in remover.